22
Turning the power off
1
Press the ON/STANDBY button.
When the setting of beep sound is [
On
], the projector beeps, and a message appears
on the screen, confirming that you wish to shut off the power. To shut off the power,
press the ON/STANDBY button again. If you do not wish to shut off the power, wait for a
while without conducting any operations. This message will disappear after a moment.
(This operation is no longer valid after the message disappears.)
2
Press the ON/STANDBY button again.
When the setting of beep sound is [
On
], the projector
beeps, and the screen disappears, but the internal
cooling fan continues to operate. Then, the projector
goes into standby mode.
During cooling, the ON/STANDBY indicator flashes.
While the indicator is flashing, the power can not be
turned back on. There is no problem with unplugging
the power cord in this state.
3
Replace the lens cap.
After use, replace the lens cap.
Note
The projector consumes about 4.5W of power in standby. We recommend that you
unplug the power cord if you will not be using the projector for an extended period.
Precautions
When you wish to restart the projector again right after turning off the power, give the
lamp time (about 5 minutes) to cool before plugging it back in. If the lamp overheats, it
may fail to light.
Right after turning off the power, the unit may become very hot, especially air exhaust,
lamp cover or the bottom of the unit. Please handle with care to avoid burn injuries.
■
•
•
•
Control panel
Remote
control
Turning the power on and off (Continued)
PJ2a̲d̲c̲Getting̲F-EN.indb 22
PJ2a̲d̲c̲Getting̲F-EN.indb 22
2011/1/12 14:22:55
2011/1/12 14:22:55
