Ricoh PJ KU600, Field Service Manual

Page: 60 / 110

8. Slightly lift up the insulating plate [A], and remove the AC inlet [B] and bracket [C].
Bottom Shielding Plate
1. Remove the lens cap. ( page 23 "Lens Cap" )
2. Remove the lamp cover and lamp module. ( page 24 "Lamp Cover, Lamp Module" )
3. Remove the top cover. ( page 26 "Top Cover (Including Mini HDMI Cable and Keypad
Rubber)" )
4. Remove the main board. ( page 34 "Main Board (Including HDBaseT Board (WUXGA
model only) and Sub Board)" )
5. Remove the shielding bracket. ( page 40 "Shielding Bracket with Rear Cover and LVPS" )
6. Remove the color wheel module. ( page 30 "Color Wheel Module (Including Photo Sensor
and Color Wheel)" )
7. Remove the rear speaker. ( page 46 "Speaker (Rear) and Speaker Rubber" )
8. Remove the right fan. ( page 43 "Right Fan " )
9. Remove the lamp housing. ( page 46 "Lamp Housing" )
10. Remove the optical system unit. ( page 48 "Optical System Unit (Including Focus Ring,
Zoom Lever, Lens Shift Dial, Lens)" )
11. Remove the PSU and insulating sheet. ( page 53 "PSU" )
12. Remove the AC inlet. ( page 56 "AC Inlet" )
2. Replacement
58