Ricoh Pentax K-3 II, Operating Manual

Page: 94 / 120

6
Ap
pend
ix
92
t
Memo
• In rare cases, the camera may not operate correctly due to
causes such as static electricity, etc. This can be remedied by
taking the battery out and putting it back in again. If the
camera operates correctly, it does not require any repairs.
Troubleshooting
Problem Cause Remedy
The camera does
not turn on.
The battery is not
installed properly. Check the orientation of the
battery.
The battery power
is low.
Charge the battery.
The shutter cannot
be released.
There is no
available space on
the memory card. Insert a memory card with
available space or delete
unwanted images.
Data is being
processed. Wait until processing is
finished.
The lens aperture
ring is set to a
position other than
9 .
Set the lens aperture ring to the
9 position or select [Enable] in
[26. Using Aperture Ring] of the
E
4 menu. (p.89)
The autofocus
mode is set to
x or z
and the subject is
not in focus.
Set the focus method to
w
and adjust focus manually.
Autofocus does
not work.
The subject is
difficult to focus
on.
v cannot work well for low-
contrast objects (the sky, white
walls, etc.), dark colors,
intricate designs, rapidly-
moving objects or scenery shot
through a window or a net-like
pattern.
Lock focus on another object
located at the same distance as
your subject, then aim at the
target and take a picture.
Alternatively, use
w .
The subject is too
close. Move away from the subject
and take a picture.
The focus cannot
be locked.
The autofocus
mode of Live View
is set to
f .
Set [Contrast AF] to e , g ,
h , or i . (p.46)
The flash does not
discharge. The flash mode is
set to
A or B .
When the flash mode is set to
A or B , the flash does not
discharge if the subject is
bright.
Change the flash mode. (p.43)
The camera is not
recognized when it
is connected to a
computer.
The USB
connection mode
is set to [PTP].
Set [USB Connection] to [MSC]
in the
D 2 menu.
Dust or dirt
particles appear in
images.
The CMOS sensor
is dirty or dusty.
Activate [Dust Removal] from
the
D 4 menu. The Dust
Removal function can be
activated every time the camera
is turned on and off.
Refer to “Sensor Cleaning”
(p.93) if the problem persists.
Pixel defects such
as bright spots
and dark spots
appear in the
image.
There are
defective pixels in
the CMOS sensor.
Activate [Pixel Mapping] from
the
D 4 menu.
It takes about 30 seconds to
correct the defective pixels, so
be sure to install a fully charged
battery.
Problem Cause Remedy