This SP slightly increases the gap between sheets in the paper path. When the machine shifts
to the CPM down mode, the paper is fed by whichever interval between sheets is longer, the
gap set with this SP or the gap determined by CPM down.
[0 to 500/0/1 mm]
Note:
• The "0" (default) setting does not mean that the gap is eliminated.
• When set to "0", the standard gap between sheets is maintained (480 mm).
1925 CutOffsetCor Not Used
Cut Length Offset Correction
Paper Thickness Default Selection
• Several SP codes in these tables reference the "Paper Thickness Default Selection" in this section. This
refers to the default setting (Thick
←→
Thin) selected for the paper type on the machine operation
panel.
To display the panel shown above:
Paper Thickness
The paper thickness can be set for the paper cassette and bypass tray only.
1. [Menu]
2. [
] or [
]> "Maintenance"> [OK]
3. "General Settings"> [OK]
4. "Paper Thickness"> [OK]
5. [
] or [
]> Select the target paper tray > [OK].
6. [
] or [
]> Select the desired paper type> [OK]
• Plain Paper
• Recycled Paper
• Translucent Paper
• Film
SP1-xxx Feed
261
5
Summary of Contents for Neptune-P1
