Obey the following cautions when handling the drive or discs.
Cautions During Installation
●
Install the drive in accordance with the specifications. Be careful to avoid locations likely to cause vibration or shock.
●
Avoid locations where there is high humidity, excessive dust, or poor ventilation.
●
Avoid locations in direct sunlight, with severe changes in humidity, or places where there are extremely high or low temperature
variations.
●
Don't use the drive near radio or television receivers. It may interfere with their reception.
●
Do not disassemble the drive. Dismantling the drive to attempt repairs or for other reasons is dangerous because the laser may
radiate outside the unit.
Cautions During Use
●
DVD-R, DVD-RW (DVD minus R and RW) and DVD-RAM media cannot be used.
●
Don't suddenly move the drive from a cold place to a warm place, or suddenly raise the room temperature. Condensation may
occur, causing abnormal operation.
●
Make sure to remove the disc before moving the drive. The disc may be damaged, causing data loss.
●
Be careful to prevent foreign objects such as liquids or metal from entering the drive. Should by chance a foreign object enter
the drive, please consult the dealer where the drive was purchased.
●
Don't use benzene or thinner to clean dirt from the drive. Don't allow chemicals such as insecticides to contact the drive. Use a
soft cloth to wipe the drive, or moisten a cloth with neutral detergent diluted with water and use it to clean particularly dirty
areas.
●
Don't cutoff the electric power while the drive is operating.
●
When connecting two E-IDE devices to the Primary or Secondary connectors, make sure that the two devices are not both
configured as Master, or both as Slave. If they are both set the same, Windows may fail to run or recognize the drives.
●
The total length of the E-IDE cable should be less than 18 inches (about 45 cm).
●
Make sure the power to the host computer is turned OFF before connecting.
●
Never insert a damaged disc into the drive.
●
In wintertime, don't use a disc soon after bringing in from outdoors. Use it only after it has reached room temperature.
Cautions Concerning Disc Cleaning
●
Remove the disc by pressing the eject button.
●
Use compressed air to clear dust from the disc. (Spray the compressed air for about 5 seconds).
●
●
After cleaning the disc with compressed air, place it on the disc tray and mount it.
●
We suggest using dry air cleaner as compressed air for cleaning.
Other Cautions
●
When moving the equipment, make sure that the disc has been removed from the drive.
●
When connecting connectors, make sure that the power is OFF. If the power is ON, there is a possibility of short circuit.
●
When not using the drive for a long period, dust may adhere to the disc tray. Before using the drive again, use dry air cleaner to
remove the dust from the tray.