Ricoh LCIT RT5090, Field Service Manual

Page: 7 / 42

1. Replacement and Adjustment
Removing Trays
• Tray 2 weighs 27 kg (60 lb) empty. Trays 1 and 3 weigh 20 kg (44 lb) each empty.
• To prevent damage to the tray and personal injury, never attempt to lift a tray alone or without
attaching the carrying handles, especially if a tray is loaded with paper.
• Two people on each side of the tray should lift the carrying handles together to lift and move the
tray.
• Never remove the tray if the LCIT has not been docked to the copier. Removing the tray while the
LCIT is standing alone can unbalance the LCIT and cause it to fall over.
• Only one set of carrying handles is attached to the side of Tray 2. Follow the procedure below to
attach and use these handles to move Tray 1, 2, or 3.
1. Pull the tray [A] out of the LCIT until it stops.
2. Remove the screws from the right rail ( x3)
3. Remove the screws from the left rail ( x3)
• You do not need to remove screw for the stopper pin bracket at the back of the left rail.
4. Remove carrying handles [A] and [B] from the right side of the tray ( x 2 ea.)
5. Use the same screws to attach the carrying handles at and .
6. With one person on each side of the tray, lift it carefully and remove it from the rails.
5