Ricoh Lanier LD130C, Operating Instructions Manual

Page: 72 / 160

• After turning the machine's power off, wait at least a few seconds before turning it back on. If the
message “Turn main Power Switch off” appears, turn the machine's power off, wait three seconds or
more, and then turn it back on again. Never turn the power back on immediately after turning it off.
1. Make sure the operation switch indicator is not lit.
2. Turn off the main power switch.
The main power indicator goes out.
• When the main power switch is turned off while using the fax function, waiting fax and print jobs may
be cancelled, and incoming fax documents not received. If you have to turn off this switch for some
reason, make sure 100% is shown as available memory on the screen before turning off the main
power switch or unplugging the power cord. Fax files in memory are deleted an hour after you turn
off the main power switch or unplug the power cord.
• For details, see “Turning Off the Main Power / In the Event of Power Failure”, Troubleshooting
.
Saving Energy
This section explains the machine's energy saving functions.
This machine has the following energy saving functions.
Energy Saver
If you do not use the machine for a certain period after an operation, or when you press the [Energy
Saver] key, the display disappears and the machine goes into Energy Saver mode. When you press
the [Energy Saver] key again, the machine returns to the ready condition. The machine uses less
electricity in Energy Saver mode.
You can change the amount of time the machine waits before switching to Energy Saver mode after
copying has finished or the last operation is performed under Panel Off Timer.
Low power mode
If you do not use the machine for a certain period, it automatically lowers its power consumption.
When you press the [Energy Saver] key, the machine returns to ready condition.
You can change the amount of time the machine waits before switching to the Low power mode under
Energy Saver Timer.
Auto Off
If the machine remains inactive for a specified period, it automatically enters the same low power
state that it enters when the operation switch is pressed (indicator unlit). This function is called “Auto
Off”.
You can change the Auto Off time under Auto Off Timer.
2. Getting Started
70
2