Ricoh HL-F1, Field Service Manual

Page: 291 / 296

2. Turn the machine on.
The machine enters the maintenance mode, then returns to the standby state. Or leave the machine for 10
minutes while keeping the power on.
Communications Errors
If a communications error occurs, the facsimile equipment emits an audible alarm (intermittent beeping) for
approximately 4 seconds, displays the corresponding error message, and prints out the transmission
verification report if the equipment is in sending operation.
Definition of error codes on the communications list
1. Calling
Code 1 Code 2 Causes
10 08 Wrong number called.
11 01 No dial tone detected before start of dialing.
11 02 Busy tone detected before dialing.
11 03 2nd dial tone not detected.
11 05 No loop current detected. *
11 06 Busy tone detected after dialing or called.
11 07 No response from the remote station in sending.
11 10 Unobtainable tone detected after dialing.
17 07 No response from the calling station in receiving.
* Available in German models only.
2. Command reception
Code 1 Code 2 Causes
20 01 Unable to detect a flag field.
20 02 Carrier was OFF for 200 ms or longer.
20 03 Abort detected ("1" in succession for 7 bits or more).
Error Indication
35
2