Ricoh G031, Service Manual

Page: 99 / 345

Install
a
tion
CHECKING THE CONNECTIONS
SM 3-5 G031/G032
The maintenance counter [C] shows the main motor work time counter (the unit is
5000 seconds).
Check the following:
•
For the main printer control board, check that the machine prints the
configuration page fully.
•
For the RAM SIMM, confirm that “Total Installed RAM” [D] on the printout
shows the size of the module just installed, plus 8 Mbytes (the base memory
on the board).
•
For the hard disk, confirm that “Hard Disk” [E] printed on the configuration
page shows the size of the hard disk.
•
For the NIB, confirm that “Network Card” [F] printed on the configuration
page shows the type of network card.
•
For the PCL version of the printer control board, check “Firmware Version”
[A].
•
For the software version of the engine control board, check “Engine Version”
[B].
If there are any problems with the above check items, reinstall the printer controller
and other options. Then set up the machine again and test it again.
Reference
F i r m w a r e V e r s i o n 2 . 2 3 . 2 2
E n g i n e V e r s i o n 1 . 1
P a g e s P r i n t e d 1 2 3 4 5 6
M a i n t e n a n c e C o u n t e r 4 3 4 5 6
T o t a l I n s t a l l e d R A M 3 6 M B
H a r d D i s k 8 1 5 M B
N e t w o r k C a r d E t h e r n e t
D I M M C a r d A t t a c h e d
M o d e l N a m e
G031I500.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]