11.9 FEED ROLLER REPLACEMENT
1. Remove the duplex unit from the tray. (See Duplex Unit Removal.)
2. Remove the feed motor. (See Feed Motor Replacement.)
3. Remove the drive gear [A] (1 E-ring) and three idle gears [B] (1 parallel
pin [C]).
4. Remove the E-ring [D] and the upper paper guide plate stopper [E] (1
shoulder screw).
5. Remove the upper and lower guide paper plates [F].
6. Remove the paper end feeler shaft [G] (1 E-ring).
7. Remove the E-ring [H] on the front side of the feed roller shaft [I].
8. Remove the feed roller shaft (2 bushings).
9. Remove the feed support roller [J], flatter [K], paper retainer [L]; then,
replace the feed roller [M] (1 E-ring and parallel pin per roller).
[H]
[I]
[L]
[K]
[J]
[G]
[M]
[F]
[D]
[C]
[A]
[E]
[B]
FT4220/4222
5-28
STM
Summary of Contents for FT4215
