4
4-38
Performing Setup from the Control Panel
Account Name
Enter the account name. This is the internal name your network recognizes, which is
not necessarily the same as User Name.
Password
Enter the password for the e-mail account.
Administrator E-mail User Name
Enter the administrator name of the administrator e-mail account. This is typically the
part of the e-mail address that precedes the @ symbol. For example, in the address
, the administrator e-mail user name is
pat
.
Administrator E-mail Domain Name
Enter the name of the domain in which the administrator has an account. This is
typically the part of the e-mail address that follows the @ symbol. For example, in the
address
, the domain name is
test.com
.
The administrator authorizes a unique e-mail address to remotely administer the Fiery
E-mail Services via e-mail. If an error occurs while you are executing a scan to e-mail,
the e-mail service sends an error message to that administrator e-mail address. The
administrator can authorize additional e-mail addresses as administrators from this
e-mail address.
Timeout (sec)
30–300 [60]
Enter the length of time, in seconds, that the E-820 should try to connect to each
e-mail server before determining that the connection is unsuccessful.
Polling Interval (sec)
1–3600 [15]
If you have enabled auto-checking for new messages in the previous option, enter
the interval in seconds at which the E-820 should automatically check for new e-mail.
