Ricoh C211, Service Manual

Page: 290 / 769

7. Position the Plastic Sheet [D] to the back side of the Video Interface
Board [E].
8. Carefully align the Video Interface Board and the Plastic Sheet to the
chassis.
CAUTION: When the Video Interface Board is attached correctly, the
Front Cover Bracket [F] should not touch the Video
Interface Board.
9. Secure the Video Interface Board and Plastic Sheet to the installed Studs
[B], use M3x6 screws with flat washers. (Note: Flat washers are not
illustrated).
10. Attach the short I/O Ribbon Cable to the Video Interface Board,
connector CN102.
11. Remove the screw securing the main power cable harness to the cable
channel to allow the cable harness to be moved, clearing the channel.
12. Remove the rear cover from the machine.
13. Working from the rear of the machine, thread the small connector end of
the Interface Harness [G] through the cable channel and to the front of
the machine, Refer to figure 3.
FIGURE 3:
REAR VIEW OF FRAME
14. Install the (2) longer Studs [H] to the chassis, as shown above.
NOTE: There may be a grounding wire secured in the right hole that is
needed for the right mounting stud. If the mounting hole is blocked,
remove the grounding wire and re-secure it to the adjacent grounding
wire screw.
Stud
[H]
Rear Frame
Interface Harness
[G]
M4 x 8 Screws
Stud
[H]
VT2105 6-6 FSM