Ricoh BOOKLET MAKER BK5010, Installation Manual

Page: 53 / 74

1-49
Installation
04 October 2007
1.5.5 CONNECTORS
1. Connect the Belt stacker cable [A] to the Trimmer ( x1).
NOTE: Unless a Book folder BF5010 also will be installed. If so, the Belt
stacker cable will connected to the Book folder instead.
2. Remove the Trimmer Terminator plug from the Booklet maker [B] ( x1).
3. Connect the Trimmer Terminator plug on the Trimmer [C] ( x1).
4. Remove the Interlock jumper [D] from the Booklet maker ( x1).
5. Connect the Interlock jumper to the Booklet maker frame [E] ( x1) (see
next spread). This jumper will be stored in this area, it will be needed at a later
date to allow the Booklet maker to function while the Trimmer is serviced.
6. Connect the communication cable to the Trimmer [F] ( x1).
NOTE: The communication cable you received with the Trimmer.
7. Connect, the other end of the communication cable, to the Booklet maker [G]
( x1). (see next page)
8. Connect the powercord to the Trimmer [H] ( x1).
9. Connect, the other end of the powercord, to the Booklet maker [ I ] ( x1)
(see next spread).
10. Mount the cable protector [J] positioned as shown with two screws in the holes
[K] and route the cables inside the cable protector ( x 2).
11. Attach the sticker “Do not lift here” [L] on the cable protector.
12. Install the cable holder on the rear side of the Trimmer.
13. Route cables through the cable holders on the rear side of the Booklet Maker
and Trimmer.
[B]
[D]
Booklet Maker without Trimmer installed
Continued on next page....
TRIMMER INSTALLATION