background image

○○○○○○○○○○○○○○○○○○

○○○○○○

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○

Remove the protective cover on the left side of the printer.
Hold the protective cover by both sides, and while pushing
the left side of the cover (

a

), open it in the direction of

the arrow (

b

), and then remove (

c

).

ZDJP041J

 Note

You cannot use the removed protective cover.

Attach the paper guide to the stand. Hold it so that the
right side bends down as shown, and then while gripping
lightly (

a

), insert it into the holes of the stand (

b

).

ZDJP042J

Insert the claws of the stand into the holes on the left side
of the printer (

a

), and then push down (

b

).

ZDJP043J

Slowly open the front cover by pulling on the two areas on
the left and right.

ZDJH007J

Remove the green screwdriver, and then close the front
cover.

Use this screwdriver for all attachment and detachment of screws.

ZHXH171J

 Note

After using the screwdriver, return it to its original position on
the inside of the front cover.

Tighten the four long screws fastening the duplex reversal

unit stand, using provided screwdriver. Fasten in the
order of 

a

c

b

c

c

c

d

, as shown.

ZDJP044J

This completes the installation of the stand. Next, install the duplex reversal unit.

 Installing the Duplex Reversal Unit

With both hands, hold the duplex reversal unit level, and
then insert the hooks into the groove of the stand. Adjust
the tip of the hooks to the line on the stand, as shown,
and then insert slowly. Do not let go of the duplex reversal
unit even after insertion.

ZHXH250J

The hooks of the duplex reversal unit clip around the bar inside the groove of the
stand.



○○○○○○○○○○○○○○○○○

All manuals and user guides at all-guides.com

Summary of Contents for Aficio 7000 Series

Page 1: ... fall and cause injury Turn off the power and then unplug the power cable from the wall outlet Lift the external tray in the direction of the arrow a and then remove b ZDJP038J Remove the two small covers on the upper left cover of the printer 1 Open the upper left cover ZHXH230J 2 Remove the two small covers by pinching and pulling them in the direction of the arrow ZHXH241J 3 Close the upper lef...

Page 2: ...then close the front cover Use this screwdriver for all attachment and detachment of screws ZHXH171J Note After using the screwdriver return it to its original position on the inside of the front cover Tighten the four long screws fastening the duplex reversal unit stand using provided screwdriver Fasten in the order of acbcccd as shown ZDJP044J This completes the installation of the stand Next in...

Page 3: ...s shown and then install the stopper removed in step ZDJP049J Make sure the auxiliary bar and stopper are installed in the positions as shown Slowly raise the duplex reversal unit and then fold it up to the printer ZDJP050J Remove the adhesive tape holdings the cable and then connect the cable from the duplex reversal unit to the upper connector on the back of the printer ZHXH260J This completes i...

Page 4: ... to its original position on the inside of the front cover This completes installation of the duplex feed unit Slowly push back the waste oil bottle in the direction of the arrow ZHXH160J Slowly close the front cover by pressing the two areas on the left and right ZDJH041J Note After finishing the installation you can check the duplex unit is installed properly Print the configuration page from th...

Reviews: