9. The upper spring housing has a 3-spoke blade
inside. This is obstructed by a white cap on the G28
and G920 pedals. Remove the white cap to expose the
3 spokes. The spring assembly has the mating slot to
fit around them.
10. Insert the spring into the housings as shown. Be
sure the curved part of the base faces upwards as
shown. The wire should exit at the base of the pedal
assembly.
Note:
This is important to prevent the wire from
getting damaged when the pedals are reassembled.
Damage to the wire is not covered by warranty.
11. Compress the spring to align the square cutout in
the load cell housing with the pivot hole in the base
and insert the pivot pin. Secure the pivot pin with the
10mm nut.
12. If not already inserted, insert the load cell wires into
the corresponding positions in the terminal block by
first pushing down on the locking tab with a small
screwdriver or other small tool. While holding down the
locking tab, insert the wire in a downward angle.
Release the locking tab when the wire is fully inserted.
Skip to step 14 if the wires are already inserted.
