GTR181 Electric Lock Manual
Rev 1
Installation for Single Swing Gate
Step 1:
Disengage the clutch of the swing arm with the Manual Release Key. Make sure you can
move the gate by hand, so the gate can swing freely during installation of the Electric Lock.
Step 2:
With the gate in the closed position, determine the best location for the lock and receiver.
The lock and receiver must be level and aligned with the opener. The lock and receiver should have a
solid surface or tube fence to provide stability
Step 3:
For a
Metallic Tube gate,
steel tube with a wall thickness of 3mm or more can be threaded
to allow the lock and receiver to be fastened using only bolts (without nuts).
Otherwise, drill holes through the fence post and fasten the lock and receiver with bolts, lock washers
and nuts. Of course you could also weld them directly.
For a
Chain Link gate,
you will need U Bolts, saddles, lock washers and nuts for the lock and
receiver.
Step 4:
Recheck the locks position and alignment, make sure the electric lock is working correctly.
Step 5:
Connect the power cables for the lock to the control board of swing gate opener and Lock
plus board. (See wiring diagrams included).
Note: Be sure that the clutch of the swing arm is engaged before you prepare to activate your
opener (Use the Manual Release Key)
