8
This section covers the service adjustments or common
procedures that may need to be made during the life of
your machine.
Verify if the following conditions for repair or
replacement are needed:
• Loosen screws.
• Switches or buttons damaged.
• Cables, plugs or sockets worn or damaged.
• Transmission chain damaged.
• Dirt Glue axis or glue pot.
The dust coming from saw
machines can lock the axis. Keep your CBC.E as
distantly as possible of saw machines.
• Any other condition that could adversely affect the safe
operation of the equipment.
CLEANING
Clean your Edgebander CBC.E is relatively easy. Use a
vacuum cleaner to remove the tape remains, and
dusting with a dry cloth. If there is any glue residue use
a resin remover and a clean cloth to remove it.
Keep the table clean after each use.
Periodically (and always with the machine off) it is
important to do all the cleaning of the machine, removing
glue residue that could affect the proper functioning of
the equipment. Clean the guides, the axes and the main
cutter carefully.
To maintain quality of the cutter, it is very important to
keep the scissors free of glue residue or tape. To clean
it, use a cloth with thinner or kerosene, gently wipe the
cutter, removing all the glue residue.
LUBRIFICATION
Once all bearings are shielded and have permanent
lubrication, just leave them like this until it is need to be
replaced. Do not lubricate them. For the other items on
this machine, an occasional application of micro-electric
machine oil is needed in the hinge that moves the glue
pot and manual cutter scissors.
Before lubricating, try cleaning the areas to be
lubricated, eliminating the accumulation of dirt.
BRACKET
Due to transport and even during use, it may be that the
glue axis turn out of bracket.
The fact that the glue axis is out of bracket causes
incorrect application of glue in the wood paneling,
applying impartial glue or not even applying any glue on
the wood.
If the glue axis of your Edgebander is out of the bracket,
you can regulate it easily by following these steps:
- Clean the glue axis, removing glue excess. For this
heat the machine until melt point of the glue, facilitating
the glue axis cleaning. Once the glue is melted, turn off
the machine, stopping the axis in order to clean it and
check the bracket.
- Support the side of a bracket on the table tabs, leaning
against the glue axis.
- If any point of the bracket face is not touching the glue
axis, you must do the following setting:
- If the top of the axis is tilted to the back of the machine,
loosen the Allen screws 5mm at point
B
(see figure
below) and press (about 1/4 turn) the hex bolts also from
the point
B
. Check the bracket again. If it is corrected,
tighten the Allen screws.
- If the top of the axis is tilted to the front of the machine,
loosen the Allen screws at point
A
and tighten (about 1/4
turn) the hex screws. Check out the bracket again. If it is
corrected, tighten the Allen screws; if not, repeat the
procedure.
MAINTENANCE SCHEDULE
Daily:
• Aspirate all dust on top and around the machine.
• Clean the guides, rubberized axis and manual cutter,
freeing of all glue residue.
• Check the level of glue on the glue pot.
