3
Additional safety rules for Edgebander:
CAUTION
: FAILURE TO ATTEND THESE
WARNINGS MAY RESULT IN PERSONAL
INJURY AND SERIOUS DAMAGE TO THE MACHINE.
Protect
the electric power supply line with at least a
20 amp fuse or a circuit breaker switch.
Make sure
that the advance is turning in the right
direction.
Make sure
that the knobs and screws are properly
tightened and safe before starting any operation.
Keep
sharp tools.
Keep
vents free of chips or dirt engines.
Keep
hands away from moving or sharp parts.
Turn off the machine
and unplug the power cord
before maintenance or adjustments of the tool.
Support
long pieces with a clamping device for wood.
Do not attempt
to operate the machine in another
voltage beyond designated.
Do not use
larger or smaller tools than recommended.
Do not apply
lubricant to the tools during use.
Do not operate
without some parts of the machine.
Do not put your hands
less than 4in from the shaft.
Do not put your hands
in closed parts of the machine
unless it is turned off and unplugged.
Do not use
lubricants or cleaners (particularly sprays
and aerosols) in the vicinity of the plastic guard. The
polycarbonate material used in the guard is sensitive
to certain chemicals.
WARNING:
Some dust created by the act of sanding,
cutting, grinding, drilling and other construction-related
activities contains chemicals that can cause cancer, birth
defects or other reproductive harm. Some examples of
these products are: Lead-based paint; crystal silica
bricks, concrete and other masonry products; and
arsenic and chromium from chemically treated wood.
CAUTION:
Do not connect the unit to the power
outlet until all instructions have been read and
understood. Always tighten the adjustment tabs before
using the machine. Think: "I can prevent accidents".
Do not operate the machine unless the guards are in
their proper places. Always use protective goggles.
Electrical connection
The Edgebander CBC.E MAKSIWA has engine 1-phase
110V. To avoid burning risk, check the voltage of your
outlet before starting the machine. If necessary make
the change of your power with the help of a specialist.
Ensure that your power supply is in accordance with the
designated on the board. A 10% decrease in voltage or
more will cause loss of power and overheating. All
equipment MAKSIWA are tested at the factory. If this
machine does not work, check the electricity supply.
Check the compatibility of your outlet and plug the
machine. Do not do patches and adaptations.
To avoid electrical shock and damage to the equipment
always ground the machine.
Familiarization
Put the machine on a smooth and flat surface. Check
the pictures and watch the descriptions to familiarize
yourself with its components. The next section will deal
with the necessary adjustments for the proper
functioning of the machine. You should know these parts
and will need to know where they are.
Especifications
Power
1.500 W
Tape Thickness
0,3 a 2,0 mm
Max. Tape Width
80 mm (3'')
Min. Worpiece Length
120 mm (4 3/4'')
Feeder Speed
5,5 m/min (18 ft/min)
Temperature Range
120°C to 220°C
(248°F to 428°F)
Voltage
110V
– 1 phase
Net Weight
52 Kg (115 pounds)
Transport and Installation
For packaging purposes, the machine is not fully
assembled. If you notice any damage caused by
transportation, while you open the package, notify your
supplier immediately. Do not operate the machine.
By
ergonomic
issues,
this
equipment must be carried by at
least two people, holding by the
handles located on the sides of
the box.
