Installation
©
Rice Lake Weighing Systems
●
All Rights Reserved
9
2.5 Scale Leveling
To accommodate minor floor unevenness, turning the load cups under each load cell cover adjusts its vertical position and
slightly changes the position of the deck a fraction of an inch. The total load cup adjustment should not exceed 1/4 in.
CAUTION: When adjusting scale, ensure load cups do not detach from load cell. The load cup stem may be damaged by
bending or stripping threads if extended beyond the maximum height adjustment.
To adjust the scale perform the following:
13. Place a level horizontally on the scale.
14. Remove four Phillips machine screws securing each load cell cover to frame.
15. Pull each cover away from frame to remove.
Figure 2-10. Load Cell Cover Retaining Screws
16. Use slotted screwdriver to change each load cup vertical position until deck is level as possible.
IMPORTANT: The scale must be level within a 1/4 in (6.35 mm).
Figure 2-11. Load Cup Adjustment
17. Reinstall each load cell cover with four Phillips machine screws.
Machine Screws
Load Cell Cover
Load Cup Stem
