682 Synergy Plus
2
Visit our website
1.2 FCC Compliance
United States
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Canada
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio
Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils
numériques de la Class A prescites dans le Règlement sur le brouillage radioélectrique edicté par le ministère des
Communications du Canada.
1.3 Operating Modes
Weigh Mode
Weigh
mode is the default mode of the indicator. The indicator displays gross or net weights as required.
User Mode
User
mode is accessible by pressing
on the front panel. Access to the Audit, Calibration, limited Setpoint, Accumulator,
Tare, Time, Date, MAC ID, Fieldbus Version and Version menus is available when in
User
mode. Access to the User menu can
be password protected (
). The User menu includes the Calibration, limited Setpoints, Accumulator,
Time and Date menus.
Setup Mode
Many of the procedures described in this manual, require the indicator to be in
Setup
mode.
See
for the procedure to enter
Setup
mode and the parameters available.
Setup
mode is accessible by
pressing the setup switch or by pressing
on the front panel when the audit jumper is in the ON position. Access to the
Setup menu can also be password protected (
).
NOTE: See
for the menu location and description of the password parameters.
1.4 Option Cards
The 682 has a single option card slot which can support the Synergy Series Option Cards. The Synergy Series Option Card kits
include instructions for installation and setup.
• Single Analog Output Option Card Kit (PN 195084)
• Relay Option Card Kit (PN 211709)
• Dual Serial Option Card Kit (PN 211710)
1.5 RJ45 Option
The 682 is available with an external RJ45 option. This external RJ45 connector is located on the backplate of the 682 and
provides quick access to Ethernet TCP/IP 10Base-T/100Base-TX communication (
).
682 indicators without the RJ45 option access Ethernet using the J8 connector on the CPU board inside of the enclosure.
Summary of Contents for REVOLUTION 682 Synergy Plus
Page 129: ......
