Rice Lake IDIMENSION 20, Assembly Instructions Manual

Page: 7 / 22

Assembly 3
2.0 Assembly
2.1 Pole Assembly
Figure 2-1. Remove Screws
1. Using the appropriate hex wrench, remove the two screws at the pole joint. Retain the screws for assembly.
Leave the other two screws in place.
2. Lay the pole out on a hard surface covered with a rug or similar soft covering.
3. Ensure that the poles are aligned correctly using the notch and pin as a guide.
4. Insert the lower half of the pole into the upper half.
Figure 2-2. Pole Assembly
5. Reinsert and tighten the screws removed in step 1.
6. Lay the pole assembly on a table or other stable surface. Ensure the power block is hanging over the edge.
Figure 2-3. Remove Power Block Screws
7. Remove the four screws that are in the bottom of the power block.
8. Insert the two pins on the base into the matching holes of the power block.
9. Reinsert and tighten the four bolts removed in step 7.
Screws to be removed
Alignment Point
Screws to be left
in place
Note
Pole Intersection
Retained Screws
Alignment Point