Rice Lake 610-10-2 Series, Technical & Operating Instructions

Page: 13 / 18

Neonatal Technical and Operating Instructions - Troubleshooting & Testing 9
6.1 Test Mode
The test mode menu is a special mode used for checking the systems’ state and for troubleshooting. Entry into
this mode is possible only when the scale is turned off. To access the test mode parameter, press and hold the
REWEIGH
key when starting the unit. Alternating between the parameters is performed by pressing the
REWEIGH
key.
Figure 6-1. Test Mode Menu Structure
Table 6-2 lists the various display messages when testing the scale.
NOTE:
< - > means that you can toggle between two values.
Step Function Display Available Parameters
1 With the scale turned
off, simultaneously
press the
REWEIGH
and ON/OFF keys
This enters into the test
mode of the scale. StArt The scale automatically advances to Step
2.
2 Identifies the software
ID IdEnt < - > 10999 Press the REWEIGH key to advance to
the next function
3 Shows the current
weight value tESt < - > 0.0 To advance to the next function, press the
REWEIGH key.
4 Shows the current A/D
value A-d < - > XXXX To advance to the next function, press the
REWEIGH key.
5 Checks for current
battery level bAt < - > XXX or nO bAt If the nO bAt is displayed, there are not
batteries in the unit.
To advance to the next function, press the
REWEIGH key.
6 This function sends the
unit back into test
mode again to cycle
through the menus
again. FACtOr < - > XXXXX Go through the menu system again or to
exit test mode, press the
ON-OFF key to
turn off the indicator.
Table 6-2. Test Mode Menu
1PXFS0GG
1PXFS0O0GG
45"35 3&8&*(),FZ
5&45
7FSTJPO
#"5
"%
'"$503
"U
1SFTTBOE
IPME