Rice Lake 140-10-7 Series, Technical And Operating Instructions

Page: 13 / 34

Dietary/Fitness Technical and Operating Instructions - Scale Configuration 9
The following table lists the various display messages and sequence when setting up the scale.
NOTE:
<-> means the display toggles between the two values.
Step Function Display Available Parameters
1 With the scale turned
off, remove the
confiiguration jumper
as shown in
Figure 6?-??. Allows the scale to enter into either
configuration or calibration mode.
2 With the scale turned
off, simultaneously
press the
On-Off/
Zero and Kg-Lb key.
Enters into
programming mode StArt Scale automatically advances to Step
3.
3 Indentifies the
software ID IdEnt<-> 11300 Press the REWEIGH key to advance
to the next step.
4 Identifies software
version Id<->11387 Press the REWEIGH key to advance
to the next step.
5 Allows selection of
decimal point setting dOt<->000.0
Default =
0.0
To change the position of the decimal
point, press the
Kg-Lb key to toggle
through the various options. To
advance to the next step, press the
REWEIGH key.
6 This indicates the
maximum allowed
weight. Any weight
above this value will
cause
StOP to appear
on the display while in
the weighing mode.
FULL<->XX.XXX
Default = 600 Lb
Note:This value is
dependent on the model you
have. Refer to the serial
number label on your scale
and set appropriately.
Use the numeric data entry (See
Section 4.0 for more information on
Gravity Correction) to change the
value. To advance to the next step,
press the
REWEIGH key.
7 This limit defines the
start of the weighing
threshold to
compensate for a key
press during the Tare
function. Limit <->0.0 Use the numeric data entry (See
“Numeric Data Entry” on page 8.) to
see the optimum weight value of 5 lbs.
To advance to the next step, press the
REWEIGH key.
7 Display divisions rOUnd<->XXXX
Default =
0.1 Lb
To change the display divisions, press
the
Kg-Lb key to toggle through the
various options.
0.1, 0.2, 0.5, 1.0, 2.0, 5.0, 10.0, 20.0.
To advance to the next step, press the
REWEIGH key.
8 Gravity value at point
of use. GrAv<-> 9.8062 Use the numeric data entry (See
Section 4.0 for more information on
Gravity Correction) to change the
value. To advance to the next step,
press the
REWEIGH key.
9 Double ranges limit drAnGe <-> 0 This parameter is preset from the
factory. To advance to the next step,
press the
REWEIGH key.
10 Weight algorithm initial
tolerance A tOL <-> 20 This parameter is preset from the
factory. To advance to the next step,
press the
REWEIGH key.
Table 4-1. Configuration Mode Menu