Page
10
/
19
4.4- Settings
Standby Mode
•
The pump enter STANDBY mode when the control valve is closed.
•
The pump stop running automatically.
•
Water pressure built up in the water discharge pipe.
Operation Mode
•
The pump enter OPERATION mode when the control valve is open.
•
The pump start running automatically.
•
Water pump out of the pipe spout.
Protection Mode
•
The pump enter PROTECTION mode when water level is lower than the impeller.
•
The pump stop running automatically.
•
Reconnect the power to restart the pump.
V. OPERATION
5.1- Intended use
•
The pump is submersible that intended for domestic use. It could be used to remove water
from flooded premises or pumping water out of well or cellar. It is not intended for
commercial, artisanal and/or industrial uses.
•
The pump is designed to work in clear water with suspended particle size not more than
5mm.
•
The pump is designed to work in water temperature not exceeding 35°C.
•
The pump is fully submersible, the immersion depth must not exceed 7 metres (refer to
Table 1).
•
Do not use the product in any way other than those stated for intended use.
WARNING! Do not use with below liquids
- flammable, corrosive or explosive liquids
- sewage, dirty water or toilet waste water
- oil or grease
5.2- Operation:
Connecting Carrying Rope (not included)
•
Attach and secure a rope, which is strong and long enough, to the carrying handle.
Connecting Pressure Hose (not included)
•
Attach and secure a suitable pressure hose to the pipe spout (refer to Fig. 1 for information).
•
When plumbing is used, ridig pipe and check valve should be used to prevent water from
flowing back.
Submerging in Water
•
Close the control valve.
