Rhyas HAM4003, Manual

Page: 5 / 12

EN
5
• Keep the main lead always away from the hot
air stream and the mouth piece;
• Put the mains switch in position ‘I or II’ to let
your hot air gun operate:
“I” = 450 degrees, air flow 300 l/min.
“0” = Off
“II” = 600 degrees, air flow 500 l/min.
When the temperature is excess 600° C, the
heats switches it off automatically, however, the
heater continues to run. When the heater has
cooled to operating temperature, the heater is
switched on again.
Switching off:
Slide the switch to 0.
Tip: If you want to get the best result, test all
appliances on a little part of the workpiece.
Use of accessoires
Fig. B
Deflector nozzle (4)
Deflects air away from glass for example when
stripping paint in window frames or softening
putty.
Fishtail nozzle (5)
Distributes air equally over small areas
4. Maintenance
Always disconnect the apparatus before
carrying out inspection or cleaning.
Never use water or other liquids to clean
the electrical parts of the hot air gun.
• Never use easy inflammable liquids for
cleaning the hot air gun, especially for the
mouthpiece.
• Regular maintenance of your hot air gun
prevents unnecessary problems. Keep the
ventilation slots of the hot air gun clean to
prevent overheating.
Troubleshooting
In case the hot air gun does not work well, we give
you subjoined some possible causes and their
solutions.
• The engine gets overheated.
• The ventilation slots of the hot air gun are
dirty.
• Clean the ventilation slots.
• The hot air gun does not start when it is
switched on.
• Interruption in the electrical circuit.
• Check the mains lead and the mains plug.
• The switch is defective.
• Pull the mains lead out of the wall socket,
because there is a chance of fire risk !
Have the hot air gun repaired at your local
dealer.
• The engine does not work, but it does
heat.
• Interruption in the electrical circuit.
• Pull the mains lead out of the wall socket,
because there is a chance of fire risk !
Have the hot air gun repaired at your local
dealer.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
Guarantee
The guarantee conditions can be found on the
separately enclosed guarantee card.