Rhyas HAM4003, Manual

Page: 4 / 12

EN
4
• Do not use the appliance under moist
circumstances;
• The metal mouthpiece gets hot. Watch out
and do not touch the metal mouthpiece;
• Prevent damage of the heating element. Do
not lock or block the mouth piece;
• Do not leave the appliance when switched on;
• Do not use the appliance for drying hair or for
drying living human beings in general;
• Do not use the appliance in a bath, above
water or in spaces where easy inflammable
liquids are used.
This appliance operates at a
temperature of 600 degrees without
visible signs of this temperature (no
flames), still there is a chance of fire
risk. Watch out for the hot air stream
from the mouth piece. This air stream
can cause burns.
When operating the appliance
• If you are going to use the hot air gun,
vapours and gas can be released during
a short time. This can be harmful for your
health. Asthmatics can suffer hindrance of it;
• Before connecting the plug to the mains
voltage you have to check if the switch is in
position “0”;
• Keep the mains lead always away from the
mouthpiece of the hot air gun;
• Keep children and animals away from the
appliance if you are using it.
Immediately switch off the appliance when:
• Plug and/or cable are defective or damaged;
• The switch is defective;
• You smell or see smoke caused by scorched
insulation from the hot air gun.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class II machine – Double insulation –
You don’t need any earthed plug
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
2
. When using a cable
reel always unwind the reel completely.
3. Using the appliance
The Hot air gun can be used for:
• Plumbing work like tube connections, solder,
bowing tubes;
• Removing paint, varnish and lacquer without
firerisk;
• Quickly drying of appliances which have
become wet;
• Drying surfaces for quick repairing;
• Removing self-adhesive labels in a clean way
placing PVC labels;
• Blistering after sticking PVC materials can be
smoothed after heating;
• Easy removing of vinyl carpeting:
• Forming all synthetics with a low temperature
(450 degrees) among which polyethylene and
PVC;
• Forming all synthetics with a high temperature
(580 degrees) among which acryl and
plexiglass;
• Smelting synthetics, among which matters
and foils with PVC layer;
• Applying heat shrinking tubes;
• Shrinkwrappers;
• Thawing tubes and engines;
• Repairing finishing layers: email of bath and
household appliances;
• Applying epoxypowder coverlayers;
• Repairing of ski’s, surf-boards and other
sports goods;
• Unscrewing too fast fixed screws and
connections.
Operation
Fig. A
You can work manually with this hot air gun or you
can put it in a vertical position.
• Check if the mains switch is on position “0”
before you connect the apparatus;