Page 8
Power Connections
NOTE:
Complete this section once the lights, wire harness and push-pull switch have
been installed.
CAUTION
: This light kit is designed for 12V DC operation only. Please be advised that
operating this light kit at a voltage over 12V DC can damage components and will void
any and all warranties.
1. Verify the cart is in the TOW position (if equipped) and the key is OFF.
2. Verify any exposed wires and the push-pull switch are not touching the frame or any
metal parts on the cart.
3. Connect the positive and negative battery connections from the light kit’s harness to
the batteries. Tighten the nuts but do not over tighten. Over tightening can destroy
the battery posts. A 48V battery pack is shown with 12V batteries.
Gas Carts: Connect the wires to the 12V battery.
48V Electric Carts with 8V Batteries for
12V Output: A voltage reducer is
required to reduce the voltage to 12V.
48V Electric Carts with 12V Batteries for
12V Output: A voltage reducer is
recommended to reduce the voltage to
12V but (1) 12V battery can also be used
as shown.
Note:
Light sparks can be normal when
connecting the batteries, but a bright
arching flash indicates there is a short in
the system. Always test the batteries
with a voltage meter as each
configuration may vary.
4. Put the cart in the RUN position (if equipped) and turn the key ON.
5. Turn the lights ON and test them to make sure they function properly.
6. Secure any loose wires with cable ties.
Your RXV Light Kit is now complete.
Please enjoy safely!
Scan QR code or use the link below to view the installation video.
https://vimeo.com/user39935056
+12V
-12V
Rear
