RHINO CY84, Operator'S Manual

Page: 102 / 146

OPERATION
CY84 03/08 Operation Section 4-14
© 2008 Alamo Group Inc.
OPERA
T
ION
8. Extend the tractor’s top 3-point link so that
when lifting the mower, the front of the deck will
raise 2 to 2½" before the tail wheel leaves the
ground. This will allow the mower to follow the
contour of uneven terrain.
NOTE: Install optional check chains when there is a
problem with the hydraulic 3-Point lift maintaining a
set height or when a constant pre-adjusted cut
height is required. See Check Chains in the
Assembly Section for this accessory.
7.2 Setting Mowing Height - Pull-Type
1. Park the tractor and mower on level ground.
2. Using the tail wheel ratchet jack or hydraulic
cylinder, position the mower so the skid shoes
are 1” less off the ground than the desired final
cut height. For example, if a 3” cut is desired,
raise or lower the mower until the skid shoes
are 2” off the ground. If a hydraulic cylinder is
used, stroke control spacers can be placed on
the hydraulic shaft to maintain a set cutting
height each time the mower is raised and
lowered.
3. Adjust the mower leveling rod so that the front
of the mower is approximately 3/4” lower that
the rear.
4. If the mower is attached to a 3-point hitch
drawbar, adjust any tractor equipped lower link
check chains, guide blocks, or sway blocks to
prevent the hitch and mower from swaying from
side to side. Never raise the 3-point lift with the
mower attached as catastrophic driveline
damage will occur.