5
Adjusting the light sensor
This adjustment will set the level of light at which the Auta-lite will stop turning the
light(s) on. Generally, the lights should not turn on when the natural light in the room
is sufficient.
To adjust the light sensor you must remove the front face plate of the Auta-lite. Use
the supplied tool to make the adjustment.
Turn the adjustment in the clockwise direction if the Auta-lite:
•
is turning on unnecessarily because there is already sufficient natural
lighting in the room.
That is, you don’t want the lights to turn on until the room is darker.
Turn the adjustment in the anti-clockwise direction if the Auta-lite:
•
is not turning on the light when there is insufficient natural lighting in
the room.
That is, the room is dark and the lights aren’t turning on.
Adjusting the timer
This adjustment will set the duration the light will stay on
for after the wireless device has triggered. This time will
reset each time the wireless device(s) is triggered. Set this
to suit your own desired requirements or specific
application.
Turn the adjustment in the clockwise direction to increase the amount
of time the light stays on for after being triggered.
If the adjustment is at its most clockwise position the setting will be
maximum.
The maximum time is approximately 1 hour
.
Turn the adjustment in the anti-clockwise direction to decrease the
amount of time the light stays on for after being triggered.
If the adjustment is at its most anti-clockwise position the setting will be 3
seconds. If the adjustment is turned clockwise just a slight amount the
minimum time will be 4 minutes
.
