Assembly Instructions
5x10x8 CycleCabana
TM
Figure 4 Finished Frame
Anchoring Frame To Ground
Once frame is square and properly supported, tighten
carriage bolts on all frame members, except for End Arch
members to Cross Rails along base, side, and top. Do not
over tighten or oval tubing. After hardware is tightened,
insert plastic end plugs (#16) (1 5/8”) & (#15) (1”) into all
open ends of frame members.
NOTE: Frame must be anchored before
installing any doors or cover.
E ach MDM Products 5x10x8 building comes with 12
EARTH CABLE ANCHORS with U-bolts and nuts.
These versatile anchors allow the frame to be secure d to
almost any surface. In addition a 36” Drive Rod is
provided to drive the anchor heads into the earth.
If the location where you are placing the building has
very hard ground or any rock in it, pre-drill the holes
before inserting anchors. Hammer drills can be rented
at most home improvement or rent-all centers. Hitting the
anchors into rock will cause the drive rod end to mushroom
inside the anchor head, and prevent the drive rod from
coming out of the hole.
V1.0
Anchor placement should be made inside the frame at the
interior corners of the unit, and midway along the sides of
the frames. Anchors secure the building to the ground, as
well as prevent spread of the frame over time.
ANCHOR STEP 1
P lace the drive rod provided into the cup of the
anchor. Using a heavy hammer drive the anchor into the
soil until 6-8 inches of cable remains above the earth.
Remove drive rod.
5
Do NOT Return Assembly To Dealer or Store. For All Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
