Page 4 of 4
Ford Ranger/ BT-50 Backbone - RFRB1
4
5
7
6
Once Pioneer Underbars have been aligned properly, tighten
all M8 hardware using 13mm socket wrench or 13mm
spanner. Ensure channel nut has rotated within Pioneer
underbar and is fixing Pioneer securely.
After underbars have been correctly fitted, place the Pioneer
Platform on top of the Backbone. Align the underbars with
the top tabs and ensure the M8 hardware fits into underbar
channel.
Install Pioneer Underbars with slots indicated (42100
REAR:
125mm from Rear (using slots)
FRONT:
100mm from Front (drill)
The rear slot will have to be drilled with an 8.5mm drill bit.
For detailed underbar installation instructions, refer to Pioneer
fitting instructions.
Assemble M8 hardware as pictured below. Complete this for
the six tabs on top of the backbone rails (2 each rail).
Note
: For easy Pioneer
installation. Align as shown
100mm
Channel Nut
Pioneer Underbar
3
Repeat previous steps for securing opposite side Backbone rail.
Ensure both Assemblies are securely positioned on the car. Check each bolt before proceeding to attaching the Pioneer Platform to the
Backbone.
FRONT
125mm
