Rhima DEKO 25iX, Operator'S Manual

Page: 18 / 40

- 17 -
USER-mode
START displays below illustrates the choice of max 6+6 different cycles.
Next display
Cycle start key (max 6+6)
Next cycle no to run
Previous display, main menu
Cycle checking
Start the cycle
Open the door, load the machine and close the door
Start the wanted cycle by pressing the start key. If needed, by pressing “Cycle checking” key,
the steps and variables of the cycle can be checked.
NOTE! The cycle variables i.e. temperatures, times and chemical dosage volumes, are pre-set
and cannot be adjusted prior to, or during the cycle. Possible changes to the pre-set cycles may
only be made by using a special code and into the cycle set-up. Validated, factory set cycles,
however, cannot be modified.
If the machine is unused for a period of
ten minutes it will go into standby mode.
By pressing the “CONTINUE” key this will
bring the machine out of standby and
open the door interlock.
18