INSTALLATION
15
There are two round pieces of insulation that fit on top
of the tank. The smaller white high density foam piece
fits over the top fitting and the larger green piece fits
around the white piece.
The aluminium disk may be supplied in one piece or two
semi circles depending on the tank size. Fit on top of the
insulation.
Locate the two aluminium dress rings around each flange
cover. Rivet them in two places on the horizontal plane.
Fit the final top fitting surround in the centre.
Note: 5000L
– the semi-circle with 2 x
standouts fits the side that houses the
flanges.
Aluminium Disk
The large plastic lid may be supplied in one piece or
two semi circles depending on the tank size. Place the
large plastic lid or the two halves on top of the tank.
If supplied in two semi circles use the plastic plugs
(supplied) to join along where the two halves meet.
Drill and screw the lid to the top of the tank at each
panel.
Dress Rings
Continue using the same process to wrap each panel
around the tank. Once all panels are joined each panel
should be tightened into the last tooth if possible. Ensure
the teeth are fully engaged along the entire length.
Drill and fit 1 x screw
(supplied) into each tooth
lock section midway between
the top and the bottom
