53
2. Note the error code, either through the flash code
on the PIM™ and/or from the Toolbox menu on the
user interface, and reference the explanation of
the fault along with troubleshooting steps in the
XTherm fault text section.
3. Press and release the
RESET
key to clear the
fault on the user interface and resume operation.
Be sure to observe the operation of the unit for a
period of time to ensure correct operation and no
reoccurrence of fault code(s).
XTherm Fault Text
Error Display
If there is an active error, then it is displayed as the first item in the Toolbox Menu and it is the default display for
the control until the error is resolved.
Table W: Error Display
Error Item
Description and Troubleshooting
OUTLET SEN
Check the outlet water sensor and its wiring.
LIMIT SEN
Check the high limit sensor and its wiring.
INLET SEN
Check the inlet sensor and its wiring.
GAS PRESS
Check PIM™ wiring.
IGNITION
Reset control, push and release RESET button
LIMIT TRIP
Boiler temperature tripped the high limit.
FLAME
False flame detected. Shut off gas supply, recycle power.
ID CARD
Identity card, check ID card and wiring.
IGN CTRL
Internal control fault. Reset power, replace control.
DELTA T
Temperature difference between the inlet and outlet exceeded the set
point. Check water flow.
LOW 24VAC
Low 24 VAC power. Check power supply wiring and transformer.
BLOW SPEED
Blower speed out of range. Check blower wiring and blower.
WARNING:
Do not use this appliance if any part
has been under water. Improper or dangerous
operation may result. Contact a qualified service
technician to inspect the boiler and to repair or
replace any part of the boiler that has been under
water prior to placing the boiler back in operation.
WARNING:
When servicing or replacing any
components of this unit be certain that:
• The gas is off.
• All electrical power is disconnected.
DANGER:
When servicing or replacing components
that are in direct contact with the water, be certain
that:
• There is no pressure in the boiler. (Pull the release
on the relief valve. Do not depend on the pressure
gauge reading).
• The boiler water is not hot.
• The electrical power is off.
CAUTION:
If overheating occurs or the gas supply
fails to shut off, do not turn off electrical power to the
circulating pump. This may aggravate the problem
and increase the likelihood of boiler damage.
Instead, shut off the gas supply to the boiler at the
gas service valve.
CAUTION:
Wiring errors can cause improper and
dangerous operation. Verify proper operation after
servicing. See wiring diagram.
