R Healthcare
8 & 9 Series
User Guide
Page
14
October 2013 Revision E
Fig 10
Remove the rearmost
screws from the canvas
and loosen off the
remaining screws.
Take one part of the
lapstrap belt and
choose the correct hole
position to suit the
width of your chair.
Slide the end of the belt
underneath the canvas
and line up the hole
with that in the canvas.
Replace and tighten all
the screws to secure
the lapstrap.
Adjust the length of the
longest belt to fit the
occupant. The belt
should secure the
occupant firmly but
without causing
discomfort.
1
2
3
Fig 11
Belt with twin webbing loops
shown in the correct orientation
Fig 12
WARNING
– DO NOT disassemble, shorten cut or drill this retaining
belt, it could seriously compromise the belts integrity and
invalidate any manufacturers warranty.
Remove the rearmost Seat
Canvas screw and loosen off
the remaining screws on both
sides of the canvas
Take one of the lap strap
fixing loops and slide the
end with the fixing hole
underneath the canvas
and line up the hole with
that in the canvas.
Replace and tighten all
the screws to secure the
lap strap. Then repeat
on the other side of the
chair seat
Adjust the length of
the longest belt to fit
the occupant. The
belt should secure
the occupant firmly
but without causing
discomfort.
