Lock Washer
B
C
STEP 2
MATTRESS SUPPORT ARM ASSEMBLY STABILIZER
RAIL ASSEMBLY MATTRESS HEIGHT ADJUSTMENT
STEP 2.1
Lay mattress support flat with stabilizer rail on each side.
NOTE:
On each end of the arm of the mattress support, there is a hole for the bolt
to pass through that corresponds to the holes located in the frame of the
mattress support.
STEP 2.2
Insert the allen bolt into the desired hole of the frame through the hole on
the arm support. Fasten the bolt with plain washers, lock washers and
hexagonal nuts provided. Repeat procedure on other arms of the mattress
support. See
DETAIL C
.
WARNING:
Set the mattress support to the desired height by adjusting the support
arms. The mattress support should be at its highest setting for newborns,
then adjusted to the lower positions as the child grows and becomes
mobile. Once the child is able to stand, the mattress support should be at
its lowest position.
STEP 2.3
Install the stabilizer rail at ends of the arm support, as illustrated in
DETAIL D
.
DETAIL C
DETAIL D
Hex Nut
Plain Washer
Allen Bolt (BB)
Allen Wrench
Open Wrech
Hex Nut
Lock Washer
Plain Washer
Mattress Support
Stabilizer Rail
HARDWARE FOR STEP 2
(BB) 1/4" x 1 1/4" Allen Bolt = 8 pcs.
Plain Washer = 8 pcs.
Lock Washer = 8 pcs.
Hex Nut = 8 pcs.
Allen Wrench = 1 pc.
11 X 70
Open Wrench = 1 pc.
Allen Bolt (BB)
Allen Bolt (BB)
Allen Bolt (BB)
Allen Bolt (BB)
Open Wrench
7/11
Summary of Contents for BELLINA
Page 1: ...1 1 1 11...
