HARDWARE FOR STEP 4
STEP 4
TODDLER RAIL ASSEMBLY
DETAIL I
DETAIL H
DETAIL J
Allen Wrench = 2 pcs
(E) Connector Nut = 2 pcs
(F) Connector Bolt = 2 pcs
Open Wrench = 1 pc
14 X 90
STEP 4.1
Gently tilt the crib and release the bolts underneath the metal brackets
holding the stabilizer rails.
NOTE:
·
When converting to toddler bed, loosen all the bolts and nuts that
connect the end panel and stationary side rail. See
DETAIL H
.
·
If mattress support is not in the lowest position, unscrew mattress
support bolts and move to the lowest position.
STEP 4.2
Repeat procedures from STEPS 1.3 - 1.4, substituting one stationary side
Rail with a toddler rail. See
DETAIL H
.
NOTE:
Fill the top holes on both end panels with bolts (E&F) provided, as in
DETAIL I
.
STEP 4.3
Repeat step 3. Installation of stabilizer rails into the end rail panel, as in
DETAIL J
.
After assembly, re-tighten all bolts to a snug fit.
DO NOT OVER TIGHTEN
.
9/9
(PACKED INSIDE TODDLER RAIL BOX)
Summary of Contents for Airin Spindle Crib
Page 1: ...1 1 1 9 ...
