RGN SRN9021, Operating Manual

Page: 8 / 14

8
NAILER CONNECTION AND OPERATION
NOTE:
The information contained in this manual is designed to assist you in the safe operation
of the nailer. Some illustrations in this Manual may show details or attachments that are
different from those on your nailer.
Air Supply, Connections and Operating Pressure
Read section titled SAFETY. Make sure of the following before operation: Air Supply
Power Source (Compressor)

Use only clean, dry, regulated compressed air as a power source for this nailer.

NEVER use oxygen or other bottled gases, as an explosion may occur.

Use suitable air compressors used to supply compressed air to this nailer

Moisture or oil in the air compressor may accelerate wear and corrosion in the
nailer.

Drain daily.
Connections
1. Fittings
Install a female coupler to the hose. The female coupler will connect to the quick release that
fits the tool.
2. Filter-Regulator-Lubricator

NEVER connect nailer to pressure which potentially exceeds 120psi.

Filter-regulator-lubricator units supply an optimum condition for the nailer and extend
the nailer life. These units should always be used.
Filter

The filter removes moisture and dirt mixed in compressed air.

Keep the filter clean by maintaining tool regularly.

Darin daily.
Regulator

The regulator controls the operating pressure for safe operation of the nailer.

Inspect the regulator before operation to be sure it operates properly.