SNAP2411
The Console port is an RS-232 serial port that may be used to configure the SNAP. Connection
to this port is made with the 9-pin to RJ-11 serial cable included with the SNAP. This is useful
when the default IP address of the SNAP cannot be used with the existing network preventing
configuration through a telnet session. See the section
Configuring the SNAP
for details of using
this port.
The power connector is a 2-pin DIN type connector. The provided AC adapter provides a 12 volt
power level to the SNAP . The SNAP can accept DC voltages ranging between 12VDC and
26VDC if alternative power supplies are to be used.
Attaching the Data/Power Cable Connector
The figure below shows the pin numbering of the Phoenix Contact, 16 pin, 3.81mm Data/Power
connector (P/N1803714). The view provided is facing the side of the connector with the screw
heads showing.
The cable comes with pins pre-crimped onto the conductors and is assembled by inserting a
crimped pin into a hole location, then tightening the screw to hold the pin securely. To verify the
pin is held firmly in place, gently pull on the conductor wire.
©
2000- 2004 Cirronet
™
Inc
11
M-2411-0012 Rev -
