HN-591
Set the
Frequency Operating Range
by clicking on the drop-down menu
and making a selection. ¹
Set
Radio Power Setting
up by
clicking on a selection. ²
Note: This list will change depending
on which radio is being used.
Set
Maximum Number of Remotes
from1 to 62.
Set
Redundant Transmit
by
selecting either ARQ enabled or ARQ
disabled.
Choose to have the
Banner Display
or not by selecting Banner disabled or
Banner enabled.
Choose the type of
Escape Sequence
by selecting Once after reset or
Unlimited times.
¹ The selections in this field will change depending on the frequency band the radio operates in. For 2.4GHz
radios, selecting one of the 802.11b bands in which to operate, the HopNet radio can be used in locations with
802.11b networks without causing interference with those networks. If there are no 802.11b networks present, it
is recommended that the radio be set to operate in the entire band which is the default. For 900MHz radios, there
will only be two bands to select.
² The Radio Power Setting controls how much power is used to transmit data. Unless the HopNet radio operates in
the 2.4GHz band and is being used in the European Union (EU) this setting should be left at the default High
Power. Because of the built-in antenna of the HopNet radio, the 10mW power setting must be used when
operating in an EU country.
©
2000- 2004 Cirronet
™
Inc
13
M-910-0012
Rev
A
