RFE 6KW DS Series, Service Manual

Page: 13 / 30

2. 485 (optional Canbus)
3. INPUT- optoinsulated -Address 3
4. INPUT- optoinsulated - Address 1
5. 5VDC
6. 485 (optional Canbus)
7. GND
8. INPUT- optoinsulated - Address 2
9. INPUT- optoinsulated - Address 0
Quick Start Transmitter
Unpack the transmitter and inspect it for transport damage. Ensure that all connectors are in
perfect condition.
Connect the RF OUT of the trasmitter to the antenna cable or a dummy load capable of dissipating
exciter output power.
WARNING: Electric shock hazard! Never handle the RF output connector when the equipment is
powered on and no load is connected. Injury or death may result.
Ensure that the POWER switch on the rear panel is set to OFF.
Connect the mains power cable to the MAINS connector on the rear panel.
FIRST POWER-ON AND SETUP
At first power to make sure that the transmitter is connected to the antenna or a dummy load,
adequate power, connect the mains plug and turn on the transmitter.
If you want to turn on the
transmitter with the lowest possible power, when the power to keep pressed the BACK
button simultaneously to the power on button.
Power-on transmitter display will show the following figure: