3.2 First time set-up
When using the unit for the first time, you must first connect video and audio connectors to monitor. After
this you can continue set-up using on-screen menus.
To control the unit first slide front panel switch to left or right position to control receiver 1 or 2
respectively. When programming is ready, the front panel switch must be slide to center position. This will
prevent accidental changes to be made while controlling other units
.
3.3 Set-up
To start set-up, press Menu key (Fig 2. no 1). Main Menu will be displayed.
Select “Configuration”.
Following settings can be selected:
-
Audio Language (recommended ALL)
-
NOTE! When MPEG-4 programs are received or scrambled channels are not descrambled (marked
with +) at the headend select “Modulator Menu”. Otherwise select “MPEG2 SD Monitor”.Start-Up
Select “Scan Multiplex” and write multiplex frequency. Then select “Scan”.
You can adjust frequency using numeric keys, left and right keys or double arrow keys.
When scanning is ready Channel List is shown.
RF-Tuote Oy, Joensuunkatu 13, 24100 Salo tel. +358-2736 6360, fax. +358-2-736 6355, [email protected], www.rf-tuote.fi
