1. Purpose of use
KV-87 regenerates incoming DVB-T mux to other frequency. This manual is valid for both single (KV-
87S) and twin (KV-87T) models.
2. Installation
The connections and indications are shown in Fig 1.
1. Control switch to program a unit. The unit is
programmed in “ON” position. The switch must be set
to “OFF” position when programming is ready
2. Channel number ( CCIR)
3. Cable-TV S channel indicator led
4. The signal led shows that the unit is powered
or
that the unit is powered
5. Signal led indicates that receiver is locked to
selected input multiplex selected transport stream
6. ANT IN
7. USB ports are for software update
8. RF OUT
9. DC IN
10.Not in use
units in chain in stand-alone
installation)
11. VIDEO/AUDIO connectors for monitoring
12. IR detector
13. Not in use
14. Signal led of output TS. Green = output signal OK,
red = parameters are not selected correct
KV-87 directly on the wall. Do not cover the air passage holes.
Signals from antenna are fed to IEC-connector at the top of unit.
Power supply is connected to DC connector at the bottom of unit.
RF OUT is connected to cable network.
VIDEO/AUDIO connectors (11) are for monitoring the unit while programming.
3. Programming
The receivers and modulators are simple to program with the remote control unit (RCU-800). The main
functions of RCU are shown in Fig 2.
RF-Tuote Oy, Joensuunkatu 13, 24100 Salo tel. +358-2736 6360, fax. +358-2-736 6355, [email protected], www.rf-tuote.fi
