13
ONE-X
Actuator
K148-A
06/2020
En
gl
is
h
O
PeratinG
mechanism
One-X
Unlocking
• Manual unlocking: shortly press the unlocking button (1) once.
• Remote unlocking: by interrupting the power supply.
• Automatic unlocking: the fusible link reacts as soon as the temperature in the duct reaches 72°C.
• Via ZENiX controller.
Resetting
• Motorised resetting
• Via ZENiX controller.
•
By applying voltage during first use (
*
).
• Manual resetting
1. Open the battery compartment (4) and press a 9V battery against the contact springs. Hold this position
until the red LED (3) emits a continuous light.
2. Control whether the indicator (2) indicates that the damper blade is open :
Remove the battery.
3. Close the battery compartment.
• LED indications
Red (status):
• Blinking 2x/second: the temperature sensor in the casing has detected a temperature above 72°C.
• Blinking 1x/second: reset active.
• Blinking 3x/second: the used battery is empty.
• Continuously lit: reset complete.
• Off: the ZENiX controller has unlocked the spring return actuator, or no supply voltage is available.
Yellow (error messages):
• Blinking 1x/second: time-out alarm; spring return actuator has not reached the open or closed position
within the set time. (ZENiX controller)
• Continuously lit: fusible link alarm active.
• Off: no time-out or fusible link alarm, or no supply voltage available.
Blue (bus):
• Continuously lit: actuator in freeze mode, which means the spring return actuator is not responding to any
command from the ZENiX controller except unfreeze.
• Blinking: bus communication active.
• Slow blinking (long on, short off): spring return actuator in Service mode.
• Off: no communication, or no supply voltage available.
• Service mode:
- Meaning: When the ONE-X is in Service mode, no fusible link alarm will be sent to the ZENiX controller.
-
Activating Service mode: by presenting briefly the battery in the ONE-X. The blue LED will start blinking slowly
(long on, short off).
- Duration of Service mode: 5 minutes
- Operating from open position:
• Press the unlocking button (1) -> close
• Touch battery -> open
- Operating from closed position:
• Touch and hold battery -> open
• Press the unlocking button (1) -> close
AUTO
(T)
72°C
ZENIX
1
9V
60” 100”
3
4
ZENIX
75’’
