RF-LAMBDA
The power beyond expectations
RF1467C
KEYS
use
＋ －
Power keys
Once pressed, the power will be increased or decreased by 1dB.
CF Frequency Key
After pressing this key, the horizontal line will appear in the frequency
screen. Then you can set the frequency. (Range: 02000~18000MHz)
HIGH
P
CF Frequency Key
Notice: You should set the 5 digital frequency numbers within the
range.
STEP key
After pressing this key, the horizontal line will appear in the step
screen. Then you can set the step. Range: 01~99MHz, Notice: You
should set the step number of double
‐
digit within the range.
Increase
key
and
decrease key
Increase or decrease the frequency by the pre
‐
set step.
POWER CW
A
y
0~9 numeric key
Set the frequency value: 02000~18000, the step value: 01~99, or the
power value:
－
CL Clear key
Clear the number.
MHz Confirmation key
When pressing this key, it means the frequency you set is valid.
dBm Confirmation key
When pressing this key, it means the power you set is valid.
ANAL
OG SIGN
－
Minus key
When pressed, the power value is changed to a negative value, and
when pressed again, it will be changed to a positive value.
PR Reset key
When pressed, it will come back to the initial frequency value of
10000, initial step value of 01, and the initial value of 00.
AL GENERA
TO
ST Storage key
After pressing this key and the key of M1/M2/M3/M4 you can save
current frequency and step.
RC Load key
After pressing this key and the key of M1/M2/M3/M4, you can load the
current frequency and step which were saved.
M1~M4 Storage bit
There are 4 different status you can save (Frequency and Step)
CM Communication key It is used to for the serial port communication . When pressed, you
OR 6-18GHZ
y
p
p
, y
can turn on the communication, then you will see the letters of
“con” in the step screen, and you can turn it off by just pressing
this key again.
RF
Radio frequency
switch
When pressed, Power screen shows:
, which means radio
frequency is turned off. When pressed again, it will be turned on.
RF-LAMBDA INC. www.rflambda.com
Sales: [email protected] Technical : [email protected]
