RFX-RMT-II SD/HD
LAST REV: DEC 2007
23
Operator’s Manual
RF ExtremeCare: 866.732.0113
8.5.4 Video Format (NTSC/PAL)
The video format may be selected NTSC or PAL;
The
E
nter button allows the
▲▼
buttons to select the required value. The
E
nter button
then stores the value and returns to the Main menu.
8.5.5 PID editor
PIDs used by the encoder and entered into the DVB transport stream may be individually
assigned.
The
E
nter button allows the
▲▼
buttons to select the required value. The
E
nter button
then stores the value and returns to the Main menu.
8.5.6 Software Inventory
The firmware versions currently installed in the transmitter can be obtained from this
menu. The serial numbers of the firmware can be used in discussions with the factory
regarding the issue status of the software.
8.5.7 Remote options
This menu allows the remote control interface to be set up for baud rate, line type (RS232
or RS485) and remote address.
8.6 Operational Menu – ASI mode
8.6.1 Ch / Frequency Menu
This menu is the same as the equivalent in the MPEG Operations menu
8.6.2 ASI options
This menu allows the modulation parameters to be individually set according to the chart in
Appendix C. This action sets the ASI data rate.
The modulation mode may be selected QPSK / 16 QAM / 64 QAM.
The FEC may be selected 1/2, 2/3, 3/4, 5/6, 7/8
The guard interval may be selected according 1/4, 1/8, 1/16, 1/32
The
E
nter button allows the
▲▼
buttons to select the required value. The
E
nter button
then stores the value and returns to the Main menu.
