RFX-RMR
Issue 1.0
page 26 of
41
9 CONFIGURING THE RECEIVER
9.1
“Switches” and Key pad” control modes
The receiver may be controlled by two methods:-
Switches
. Allows selection of RF channel and digital/analog receiving. In this configuration some
of the menu screens are omitted since control from the key pad is disabled.
Keypad
Allows full selection of all parameters through the keypad. In this configuration the front
panel switches for RF channel and digital/analog mode are disabled.
Selection of “Switches” and Key pad” control modes is made via the Engineering menu as described
in section 9.5.1
9.2 Status
Monitoring
The red/green ‘status’ LED on the front panel indicates the condition of the RFX-RMR, if a fault or
warning exists the LED will indicate Red and the Status menu will indicate the nature of the fault /
warning. During initialization of the unit the Status LED will be off.
9.3
Top level Menu
Four charts showing the menu trees of the RFX-RMR are included in this manual. These are for:
Operations menu
– Digital receiving mode
Engineering menu
– Digital receiving mode
Operations menu
– Analog receiving mode
Engineering menu
– Analog receiving mode
The RFX-RMR is configured using an LCD display and six push buttons. These are arranged as four
navigation buttons (A, B,
▲
and
▼
), plus Enter and Cancel buttons.
The Enter button is used to store the modified parameter in non-volatile memory; this parameter will
then be used to configure the RFX-RMR and will also become the default value when next powered
on.
The Cancel button can be used to exit a menu without storing the parameter in memory.
Various menu levels are provided to allow the operator to access the different hardware and operating
parameters:
9.3.1 Initialization
Menu
At switch on the status of the initialization is displayed. If any errors are found with the initialization of
the major functions an error message will be displayed. During initialization the Status LED will be off.
