1. General Information
1.1 Introduction
This instruction manual describes the Reznor Recessed Warm Air Ceiling Heaters.
The heater is designed for discreet positioning in a suspended 600mm ceiling within
retail or commercial premises. It can fit a recess as shallow as 210mm.
1.2 General
All installations must be in accordance with the regulations in force in the country of use.
These instructions must be handed to the user on completion of the installation.
Installers and service engineers must be able to demonstrate competence and be
suitably qualified in accordance with the regulations in force in the country of use.
To ensure continued and safe operation it is recommended that the appliance is
serviced annually.
The heater outlet / inlet must not be obstructed during use.
1.3 Electrical Supply
Electrical supply is 230/240V single phase, Neutral and Earth. The maximum cable
inlet size is 4mm².
It is recommended that the electrical supply to the base unit in the heater is via
an appropriate switched isolator in accordance with the regulations in force in the
country of use and must be via a fused isolator having a contact separation of greater
than 3mm on all poles.
All units must be wired in accordance with I.E.E regulations for the Electrical
Equipment of Buildings and the installer should ensure that a suitable isolating switch
is connected in the mains supply.
1.4 Controller `RX` models
The ACT03 – RX, ACT04 – RX, ACT06
– RX heaters are supplied without a
controller. The `RX` models will not work
without the controller. See section 5.2 for
more details.
Consort Wireless controller CRX2
Page 3
