X
X
X
X
9.
Install a full width siding panel. DO NOT nail the long edge that overlaps the door siding
panel. You can nail this edge after the wall panels are installed later.
10. Install the last panel. Separate the wall panels.
8.
Butt the other 8' wall frame against the center door frame. DO NOT nail frames together.
This will enable you to separate the wall panels making them easier to handle. Temporarily
butting the frames together enables you to align the siding where it overlaps the adjoining
wall panel.
Do Not Nail Along Edge
LAP Edge
Step 7
Apply Siding to Front Wall Frames Continued
1.
Cut a 2x4-6' board to a length of 64-1/2". Butt (2) two 68-1/2" boards together. Center the
64-1/2" long 2x4 board (used as a door spacer) on top and screw the boards together using
(4) four 2-1/2" wood screws.
2.
Indicate where the wall studs will be located by drawing a line and placing an 'X' mark
next to the line. The wall stud will be installed over, covering, the 'X' marks.
19-3/4"
36-1/4"
2x4 - 68-1/2" Boards
64-1/2' Board (Door Spacer)
19-3/4"
Step 8
Assemble Bottom Plate with Door Spacer
