2.
Remove 2x4 blocks. Save blocks,
some will be used when installing
gables. The remaining (2) two
trusses with one gusset will be used
in a later step.
4.
Install a 67-1/2" door header between
the front wall panels. Secure with 10d
sinkers. Nail through the top 2x4 plate
and the wall stud.
Step 6
Set Walls
1.
Erect wall panels. IMPORTANT: Make sure walls are plum and square. Secure wall panels
together at the corners. Use (4) four 10d sinkers per corner. Nail wall panels to the floor. Nail
through the bottom plate. Space 10d sinkers 24" apart.
Step 5
Install Collar Ties
1.
Select (3) three trusses that have gussets installed
on both sides and install a 1x4-72" long primed board
on one side as shown. Use (4) four 6d common nails
on each end.
1x4 Collar Tie
Board is Primed
2x4 Wall Brace
67-1/2" Door
Header
2.
Remove the (2) 2x4s screwed to the
pallet. Use thes to brace the walls
next to door opening. The bit for the
screws is in the hardware bag.
3.
Use (2) two of the 2x4s boards to
brace the door walls to hold them
straight. Save the 2x4s, they will be
used in a later step